Cooling Tower Control Panels on INDEECO

Home


All Categories > Electric Immersion Heaters > Control Panels > Cooling Tower Control Panels > Cooling Tower Control Panels


	Cooling Tower Control Panels

Save To Favorites

Cooling Tower Control Panels

The complete package consist of :

INDEECO offers the following options :

Standard Features

Advantages

Solid-State Control : Pre-set 45° F ON/OFF temperature control with 5° F switching differential and built-in low water cutoff. Circuit board LED’s provide visual indication of heater-on and liquid level status.
Ambient Temperature Range : -40° F to 150° F
Fail Safe : Output relay is de-energized if the input sensor is either open or short-circuited. This prevents heater burnout problems.
NEMA 4X enclosure with pre-mounted electrical hubs for conduit connections.
Single probe to sense both water temperature and water level. Sensor probe supplied with 12-foot outdoor rated cord pre-connected to control panel. Probe also supplied with PVC hub connector for attachments through cooling tower basin wall.
Nameplate showing maximum kW and amp ratings at system volts/phase.
System Wiring Diagram.
Installation and Operating Instructions.
Rated for maximum of 40 amps or 50 amps with disconnect switch when specified.
Suitable for multiple heaters per basin (maximum of 2 on 40 amp panel).
Disconnect switch with door interlock and operator handle, which can be padlocked in the "OFF" position.
Dimensions :
8" x 10" x 6" for 40 amp size
10" x 12" x 7" for 50 amp size
14" x 16" x 8" for two circuits
Control panels rated greater than 50 amps are supplied with two circuits and offered either with built-in fusing or a circuit breaker for each circuit.